MENU

dry density of recycled aggregate

Get Price And Support

Fill in this form or click the service online, all questions will be answered.

A Review Paper on use of Recycled Aggregates in

workability of concrete with natural and recycled aggregate is almost the same if ―water saturated—surface dry recycled aggregate is used. Bulk density of fresh concrete is slightly decreased with increasing quantity of recycled aggregate. International Journal of Engineering Research Technology (IJERT) ISSN 2278-0181

Get price

Application of Conventionally Recycled Coarse

Table 1 Quality of recycled coarse aggregate. Typesofcoarse aggregate Code Oven-dry density(g/cm3) Surface-dry density(g/cm3) Water absorption(%) Materialpassing 75μmsieve(%) Massperunit volume(kg/L) Solidcontentin aggregate(%) Fineness modulus Middle-quality M 2.36 2.47 4.8 0.64 1.51 64.1 6.51 Low-quality L 2.33 2.46 5.48 2.1 1.41 60.5 6.24

Get price

Action of gypsum on recycled aggregate concrete

aggregate seems to improve the physical properties and to increase the dry density (CRC05 and BRCOS). Except the fine recycled aggregate obtained by secondary crushing of reinforced concrete and hydraulic binder treated materials, the absorption capacity of recycled aggregates is higher than the thresholds fixed by the French standards, according

Get price

MASTER THESIS UPCommons

incorporating recycled aggregates (RA) into rammed earth would greatly contribute sustainable practices in the construction industry and promote the wider use of this building technology. The overall target of this study is to improve the knowledge of rammed earth structures that

Get price

Volume-to-Weight Conversion Factors, April 2016

EPA's 1997 report, "Measuring Recycling A Guide for State and Local Governments", was a guide to facilitate standardization of MSW data collection at the local level, which included volume-to-weight conversion factors for comparing recovery efforts between municipalities, regions and states.

Get price

Evaluation on the Surface Modification of Recycled Fine

decreases when they are used for recycled aggregate concrete (RAC) because of the low qualities (i.e., high water-absorption rate and low density) caused by

Get price

ENHANCEMENT OF RECYCLED AGGREGATE CONCRETE

ENHANCEMENT OF RECYCLED AGGREGATE CONCRETE PROPERTIES BY A NEW TREATMENT METHOD *Ngoc Kien Bui. 1, Tomoaki Satomi Aggregate Properties Fine aggregate Relative density SSD 2.40 Apparent relative density 2.48 Relative density oven-dry basis 2.35 Water absorption (%) 2.21 Unit weight (bulk density) (kg/m. 3

Get price

Aggregates and Earthworks Testing Southern Testing

Bulk Dry Density BS1377-27 BS EN ISO 17892-2 The density of soils depends on the density of the solid particles, on the porosity and the moisture content. The dry density is used in the evaluation of porosity and voids ratio. It is frequently used in road construction for the determination of the state of compaction of fill material.

Get price

PROPERTIES AND FROST DURABILITY OF RECYCLED AGGREGATE

Properties of bulk aggregate and concrete were investigated with RCA from the recycling plant of BA Gjenvinning in Oslo. The coarse RCA can probably be classified as Type II concrete aggregate following Rilem (and CEN) recommendations since absorption (5,7-6,3 %) and dry density (2280-2240 kg/m 3 ) agree with typical RCA values.

Get price

HOW TO TEST AGGREGATE FOR BULK DENSITY AND VOIDS

Jan 09, 2015Level the top surface of the aggregate in the metal measure, with a straightedge or tamping bar. Determine the weight of the aggregate in the measure and record the weight "W" in kg. Calculation for Loose Bulk Density. Loose unit weight or bulk density = W/V. Where, W = Weight of loose aggregate in cylindrical metal measure, kg

Get price

Waste Fibers in Cement-Stabilized Recycled Aggregate

of the fibers in the aggregate-cement matrix. Density Measurements Nuclear gauge density determinations on a companion test pad con sisting of only recycled aggregate showed that the average dry den-32 Kg (2%1 Control Control Tire Straps No Fibers No Fibers 5.5 8 Kg (0.5%) 1 Two Extra Bags Control Shredded Plastic of Cement2 No Fibers 5.5

Get price
Authors Yijin Li Jian YinAbout Compaction Base course Portland cement Cement Shrinkage Compressive str

ITEM 304 AGGREGATE BASE Pages

If the moisture is greater than 2 percent above SSD, then the Department will calculate the number of cubic yards (cubic meters) based on the dry density and dry weight. The Department will determine the pounds per cubic yard (kilograms per cubic meter) for aggregate mixtures by using 100 percent of the test section maximum dry density obtained in 304.05 .

Get price

Literature Search and Report On Recycled Asphalt

On Recycled Asphalt Pavement and Recycled Concrete Aggregate TPF-5 (129) Recycled Unbound Materials the optimum moisture content (OMC) and the maximum dry density (MDD) of a material. Atterberg limits of recycled aggregates are assessed using

Get price

Aggregates and Soils Testing ACS Group of Companies

Particle Density Water Absorption BS EN 1097-6 Particle density, sometimes referred to as specific gravity and absorption to show porosity of the aggregate when used in conjunction with Loose Bulk Density and Voids test.

Get price

A Report on the Use of Recycled Aggregates in Low

The density of concrete containing recycled aggregates was less than that of the normal CQncrete (2,400 kglm'). Furthennore, the density of concrete containing recycled aggregates from Tseung Kwan 0 (about 2,300 kglm3) is generally slightly higher than that from Kai Tak (about 2,250 kglm').

Get price

A DRY PROCESS FOR RECYCLING CONCRETE AS AGGREGATE

a dry process for recycling concrete as aggregate 7th December 2009 14th March 2016 The uses to which recycled concrete can be put are limited by the quality achievable using standard crushing and screening production methods The inability to meet quality requirements means that much potentially valuable aggregate is relegated to low-value applications such as general fill, sub-bases, and capping

Get price

Aggregate Bulk density and Voids test wecivilengineers.blog

Dec 04, 2018What is Bulk Density of aggregate? It is the mass of the unit volume of bulk aggregate material. The term volume includes the volume of the individual particle and the volume of the voids between the particles. Bulk density is used in weight and volume batching both. What is Voids in Aggregate ? It isContinue reading Aggregate Bulk density and Voids test

Get price

Coarse Aggregate Definition Density Video Lesson

The relative density is a ratio that describes the density of the aggregate relative to the density of water. A typical range for natural coarse aggregate is 2.4 to 2.9, meaning that the coarse aggregate is 2.4 to 2.9 times the density of water.

Get price

CONCRETE MADE FROM RECYCLED AGGREGATE

The lower dry density of recycled aggregate, when compared to natural dense aggregate, results in a higher absorptive capacity for water . This aspect was be specially considered in using consistency controlled concrete production. During rainy seasons the unsheltered recycled aggregate is very damp and generally completely water saturated.

Get price

Aggregates for Concrete GreenSpec

'Aggregate' is a term for any particulate material. It includes gravel, crushed stone, sand, slag, recycled concrete and geosynthetic aggregates. Aggregate may be natural, manufactured or recycled. Aggregates make up some 6080% of the concrete mix. They provide compressive strength and bulk to

Get price

What is the density of recycled coarse aggregate? Quora

What is the density of recycled coarse aggregate? I was part of our national code committee when we wrote about recycled aggregates. I guess you are asking about the bulk density. Clearly, the particle density will be around that of the concrete f

Get price

916 SOIL AND SOIL AGGREGATE BORROW SHA MediaWiki

A soil or soil aggregate mixture meeting the following Maximum dry density and optimum moisture content of the material per T 180, Method C unless the material has more than 35 percent retained on the No. 4 sieve, in which case Method D shall be used.

Get price

How to Use Crushed Recycled Glass as Aggregate for

The desired level of compaction is generally 90 to 95% of maximum dry density. The glass processor should keep data on the dry density of processed glass from that facility, and, if possible, a lab confirmation should be performed for the specific job. The level of compaction should be field-verified by in

Get price

Use of RECYCLED AGGREGATES In CONCRETE- A Paradigm

The recycled aggregate generally meets all the standard requirements of aggregate used in concrete. Specific Gravity and Water Absorption The specific gravity (saturated surface dry condition) of recycled concrete aggregate was found from 2.35 to 2.58 which are lower as compared to natural aggregates.

Get price

ENERGY EFFICIENCY ASPECTS OF RECYCLED

ENERGY EFFICIENCY ASPECTS OF RECYCLED AGGREGATE CONCRETE Ivana Banjad Pečur reported literature values for the dry concrete with approximately the same density. It has to be noted here, that concrete which is made with natural aggregates with the density of 2400 kg/m3 and is usually being used for this kind of applications in Structural

Get price

1 Stiffness Properties of Recycled Concrete Aggregate

Stiffness Properties of Recycled Concrete Aggregate/Polyethylene Plastic . 2. Granule. s. in . Unbound Pavement Applications. 3. 4. 135 a mold with the diameter of 152.4 mm and height of 116.43 mm. Dry density versus moisture 136 content curves were then drawn in

Get price

Development Of Guide Specifications For Recycled

The lower density values of recycled aggregates compared to conventional aggregates arise mainly from relatively porous and less dense residual mortar lumps or particles adhering to the surfaces of original natural aggregate particles. The specific gravity of coarse recycled aggregate ranges from 2.2 to 2.5, which is slightly lower than that of conventional aggregates. The fines fraction of recycled

Get price

Mix Design of Cement-Stabilized Recycled Aggregate Base

The results showed that the use of recycled concrete aggregates increased the optimum moisture content and decreased the maximum dry density of base course materials compared to those of natural base materials. The effect of recycled aggregate replacement on un-confined compressive strength was discussed at 7, 28 and 90 days.

Get price

what is the density of 6f1 stone BINQ Mining

Jun 11, 2013designations 6F1 and 6F2 are now reserved for material excavated from within the density, optimum moisture content and water- soluble sulfate content when More detailed Grip-Rite #13 x 2 in. 6D Bright Steel Finish Nails (1 lb. Pack)- 6F1 at

Get price

International Journal of Engineering Trends and

2. Recycled aggregate is well graded as natural aggregate. 3. The water absorption capacity of coarse recycled aggregate is about two times or more than natural coarse aggregates. 4. The dry density of coarse recycled aggregate is lower than dry density of natural aggregate. NA RCA FIGURE (4) COMPARISON BETWEEN NA RCA

Get price